Air flow in case..

munkE_pOo · Post by **munkE_pOo** » Fri Aug 02, 2002 7:50 pm

Errrr ...I hope this works ...First time here... I gots a question tho.. I was reading bout some air flow and some of you said its better for it to be even..and some said its better for more intake...I dunno. Can you tell me what you have in your rig.....And also ....With the air flow someone said it screws it up when u have a fan on the side. Is it that bad? Well I have a great idea for a mod and I plan on doing it when i not poor

You wait till i finish my mod!!! itll be slick!! lata all

Hipnotic_Tranz · Post by **Hipnotic_Tranz** » Fri Aug 02, 2002 10:05 pm

This debate has gone on as long as case modding has been going on and I don't think there is a "right" answer. Best thing to do is experiment, if possible. I have a Lian-Li with two 80mm for intake and one for exaust (well two if you count the 80mm fan in my power-supply, but thats a given really). My thinking is that it would be better to have more for exaust than for intake, that way it would drag the 'cool' air in (along with a ton of dust

).

Fu Manchu · Post by **Fu Manchu** » Sat Aug 03, 2002 12:37 am

i dont think thereis much difference either way .. as long as you have a lot of air moving through the case

©LINT · Post by **©LINT** » Sat Aug 03, 2002 12:27 pm

munkE_pOo · Post by **munkE_pOo** » Sun Aug 04, 2002 1:59 am

Thanks for the info guys...Your right i will have to experiment to find out for myself!!!
Later

PCA Forums

Air flow in case..

Air flow in case..

Thxs for info guys